Qualifying ages: 12-17 years old with a parents consent.​

TOAST PROMOTIONS
​YOUTH Compacts 

Any 1980's or newer front wheel drive.

1. FRESH cars only.
2. Youth drivers may be accompanies by a parent or legal guardian ONLY as their passenger and must provide this information at the time of signing in. In no way shape or form as the youth’s passenger are you allowed to control, assist, maneuver, etc any component of the vehicle. If you are caught, the driver will be disqualified.
3. ONLY AFTERMARKET PARTS: headers and any wheel/tire combo.
4. You may strip all interior and exterior parts, all glass must be completely removed (front windshield may be left in)
5. You may move wire harness to backside of motor, do not move to inside of car
6. All doors, trunk and hood must be wired/chained shut. 6 spots per door (double stranded). 6 spots on trunk (double standard) cannot go around frame or bumper. Must be sheet metal to sheet metal, trunk may be completely removed but you lose your 6 spots of wire or chain. 6 spots on hood (double standard) these must be sheet metal to sheet metal. Nothing to bumper. 
7. You may relocate (1) battery to passenger floor board or passenger seat. Must be tight and not moving around. Aftermarket fuel cell aloud to be relocated to rear seat area. Must be bolted to floor (no plates, no bars, no nothing but floor board). If running a fuel pump please add a shut off switch (unless it shuts off with key). Factory tank may be left under car if it’s located in front of rear axles. 
8. Any 1980 newer bumper aloud, may be welded on solid with a 6x6 plate attached to bumper. Plate may be welded solid to frame. Plate must be completely flat to frame. It cannot extend down frame at all.
9. Frames may be dimpled or notched in the rear. Front frame may be hard nosed to core support. Nothing past core support. That’s all your aloud to do to the frame. 
10. Absolutely no welded anywhere on car besides bumper and cage! 
11. You must run a rear seat bar (4”x4” max) It must be welded to post of car with 4”x4” plate and it must be at least 5 inches off the floor. 
12. You may have a floating 4 point, 4 bar cage That’s it! No gas tank holder, down legs ,guests nothing.
13. May have a plate on the outside of the drivers door .
14. Hoods and trunks must be open for inspection (yes they will be open so don’t come with them tied down) absolutely no pre bending of trunk/quarters/hood or anything else you can think of. 

If you have to call and ask a question the answer is 99% a no, these rules are stock, STREET STOCK!!!!! If your caught with anything done to frame or body you will load! This should be a one time through inspection type build!!! There is absolutely NO GREY AREA in these rules. 

​Please call Nick King for any questions 513-571-7547.

RULE BOOK DISCLAIMER

The rules and/or regulations set forth herein are designed to provide for the orderly conduct of racing events and to establish minimum acceptable requirements for such events. These rules shall govern the condition of all events, and by participating in these events, all participants are deemed to have complied with these rules. NO EXPRESSED OR IMPLIED WARRANTY OF SAFETY SHALL RESULT FROM PUBLICATIONS OF OR COMPLIANCE WITH THESE RULES AND OR REGULATIONS. They are intended as a guide for the conduct of the sport and are in no way a guarantee against injury or death to a participant, spectator, or official.

​The race director shall be empowered to permit reasonable and appropriate deviation from any of the specifications herein or impose any further restrictions that in his/her opinion does not alter the minimum acceptable requirements. NO EXPRESSED OR IMPLIED WARRANTY OF SAFETY SHALL RESULT FROM SUCH ALTERATION OF SPECIFICATIONS. Any interpretation or deviation of these rules is left to the discretion of the officials. Their decision is final.